RELEASE: WatchMon toolkit 1.0.28

Download setup at WatchMonToolkitInstaller_1.0.28.msi

Software 1.0.28 - firmware 1.40

New Features

  • Expansion functionality for
    • Critical recovery logic for multi battery recovery
    • Critical pulse On / Off output with timeout
    • Charge / Discharge limp limited power mode
    • Critical Fault sensor input for Contactor / Circuit breaker to add loop back verification.
  • Backward compatible software to connect in read only mode for older versions as far back as back to SW1.0.11 Aug-2016.


  • Extra status icon for read only, Firmware Upgrade.
  • Bypass Auto Level extra function to handle no shunt condition
  • New Status LED option with solid 8 segment Soc% bar meter
  • Critical Control setup
    • Extra dialog with less used parameters
    • New parameters related to Critical recovery.


  • When saving setup verify against collected info not just old cache records
  • Double check that Factory reset has been invoked on System hardware setup.

Alternative release notes

Previous release (software 1.0.27)
Next release (software 1.0.29)

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us