How to connect the CellMon modules to the WatchMon

Connecting the CellMon and CMU cable to WatchMon4

Connect the CMU cable (grey cable with blue heat-shrink) to the blue indication painted on the WatchMon4 cover as per photos below:

Why do I need the CMU cable?
This allows the WatchMon4 hardware to be installed at a higher and unobstructed position outside the battery box. This also improves the Wifi signal significantly. The CMU cable makes connecting the CellMons much easier and more intuitive, using the existing connectors rather than having the risk of connecting something wrong and damaging the WatchMon or CellMon hardware.
It is recommended to start by connecting cell #1 (the most negative battery) to the 4 pin CMU cable connector (small black box highlighted on the photo below). Then, work up the chain to the most positive battery, finishing the chain back on the 2 pin CMU cable connector.

CAUTION: Whilst preparing the cables for insertion into the WatchMon terminals, ensure that both the 2 pin and 4 pin connectors are not connected to the CellMon until after you have prepared the cables. 

CAUTION: Whilst initially setting up the cell monitors, make sure to only have the USB plugged in and then attempt to connect the CellMon wires. We recommend that you disconnect the WatchMon power supply (2 pin connector) and all other cabling until you have successfully connected the CellMon network. Ensure that the software network testing utility has confirmed that the communication link is working properly.

Closer look of the CellMon daisy chain:

Different types of CellMons:

Still need help? Contact Us Contact Us