Initially connecting to a WatchMon

You WatchMon will most likely automatically connect via USB when the WatchMon is first plugged in if software open and USB driver installed.  However if this doesn't occur you can fix by clicking Connect on your setup checklist

or click on connection icon at bottom left of screen (wifi or usb icon) and following the below steps.

Choose Method = USB and your system should appear.  If it doesn't check you have the correct Comm Port.

(Troubleshooting - if USB does not work try USB Legacy.  If your WatchMon shows up then Firmware needs updating as it is out of sync with the software)

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us