PacMon - FAQ and how to guides (discontinued)

Overview of the software

How to install the BmsSuite software

How to commission the BmsSuite software

How to Backup and Restore the configuration

How to import the hardware configuration back into BmsSuite

How to check that the hardware matches the configuration

How to find the current software version

How to update the firmware via BmsSuite

How to configure the BMS for off-grid solar with ChokeMon

How to automatically switch off/on the screen / monitor based on SiMon running

How to Re-Calibration the CellMon voltage

How to review recent e-Meter History sessions

How to tailor the BmsSuite charting screens

How to reset the CellMon Session chart

How to test and verify the Bypass function

How to alter the left panel logo

How to use voice commands from the BmsSuite

How to verify that the Software is the current release

How to control and interpret the recharging session report

How to specify the startup screen that launch from ServiceCentre

How to log system data to files

How to find cabling faults by running the Network Tester

How to locate a specific CellMon using the LED keypad

How to modify the recharging current to the TCCharger (canbus)

How to setup cloud data storage for the BMS via ThingSpeak.com

Understanding the SystemController host

Understanding the UMonHub host

Understanding the CellMon advanced configuration

Understanding the Charging advanced configuration

Understanding the status icons of the Service Centre

Understanding the System Tray

Understanding the SystemHost advanced configuration

Where to find the configuration backup files from autosave

Troubleshooting - Error: Cannot save whilst in read only mode via USB

Still need help? Contact Us Contact Us