VIDEO - Upgrade Kit - How to add the Expansion Board to a WatchMon4Solo

Here is an instructional VIDEOshowing all the process step-by-step

Here are the parts you will be required to perform for this upgrade:

Expansion Board

26pin ribbon cable

3D printed protective cover for WatchMon4

Din-rail PCB holder

You will be required to remove the 3D printed protective cover from your WatchMon4 

Here is a photo of the WatchMon4 with the Expansion Board after the upgrade (please watch the step-by-step  VIDEO for instructions)

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us